Cura 2.1.2 - Z Seam blob - UltiMaker Cura - UltiMaker Community

Ladies and gents, Question about Cura 2.1.2 and Z Seam - on some of the prints it looks like a thick blobby line. For example calibration cube, one corner is complete blob all the way up. I'm pretty certain that this wasn't happening on older versions of Cura and I'm certain that it's not a print

Extrusion Suddenly changes from smooth to Blobs at random Layer heights CURA5.2.1 - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Z Seam Alignment issue · Issue #8704 · Ultimaker/Cura · GitHub

Cura 2.1.2 - Z Seam blob - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Cura 2.1.2 - Z Seam blob - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Help with blobs on Z seam : r/AnkerMake

Cura 2.1.2 - Z Seam blob - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

5.1.0) Model Greyed Out On Buildplate Despite Having Room · Issue #13115 · Ultimaker/Cura · GitHub

Support Blocker/Modify Overlaps change not working with Fuzzy Skin · Issue #8853 · Ultimaker/Cura · GitHub

I finished a print with an invisible z seam. The z seam is supposed to be on the base of the print(back location in Cura), and the only thing I can find

Is there an equivalent in Cura to randomize seam position that Slic3r has? - Improve your 3D prints - UltiMaker Community of 3D Printing Experts