Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

I’m trying to understand how to tune overhangs for my Polymaker ASA filament. I had dialed the fan speed way down to promote layer adhesion, except for overhangs. But overhangs came out shitty: I had: 0% fan @ 35s 20% fan @ 5s 100% fan for overhangs I then adopted the bambu ASA fan settings (leaving everything else the same): 25% @ 35s 90% @ 3s 80% for overhangs The result is much better: Notice that the bad model has 100% fan for overhangs and the good one only 80%. So is less fan

TPU Vol. Flow rate issue. Any solution rather than entering speeds by calculating ? : r/BambuLab

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

Error after upgrading to Bambu Studio v1.7.7.88 : r/BambuLab

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

How to do support structures for small round overhangs in Bambu Studio : r/BambuLab

Bambu Lab P1P 3D printer tested extremely fast and precise

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

Print Quality Issue, Overhangs, X1 Carbon, PLA - Bambu Studio - Bambu Lab Community Forum

Print Quality Issue, Overhangs, X1 Carbon, PLA - #22 by Rhotix - Bambu Studio - Bambu Lab Community Forum

The 3 Best 3D Printers for 2023

Bambu Studio Fine Tuning: Tips And Tricks For X1 And P1P

Tuning overhangs - Bambu Studio - Bambu Lab Community Forum

This is quite nice for my standards but I feel like Bambu printers should do better. Thoughts? : r/BambuLab