Cura 5.3 unnecessary move after toolchange in gcode - UltiMaker

Hi, i build a voron with toolchanger running klipper. I use cura since 2014 but i cant solve that problem. i try to explain it. before toolchange, klipper stores the toolheadposition(blue line) then retract, z hop, toolchange etc. after toolchange the toolhead goes to the old position (green line

Cura 5.3 unnecessary move after toolchange in gcode - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

New here! Gcode settings - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

preparing G-code - UltiMaker 3D printers - UltiMaker Community of 3D Printing Experts

Cura makes a bunch of unnecessary moves near end of layer. · Issue #8138 · Ultimaker/Cura · GitHub

Ultimaker cura slices fine but on reading the gcode again through Cura, it shows a faulty 2nd layer [Screenshot attached]. Not sure if it is causing any real issue, but cannot find

Cura makes a bunch of unnecessary moves near end of layer. · Issue #8138 · Ultimaker/Cura · GitHub

Ultimaker cura slices fine but on reading the gcode again through Cura, it shows a faulty 2nd layer [Screenshot attached]. Not sure if it is causing any real issue, but cannot find

Cura 3.0 [Modify G-Code] function does not work - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Cura 441 doesn't save gcode to removable drive - UltiMaker Cura - UltiMaker Community of 3D Printing Experts