First layers K8400 - Software (Repetier & Cura) - Whadda forum

Forum. I have a problem printing the first two layers. With a hole within the model, the outline is only printed twice, while the edges are printed 3x for the outline of the entire model. With the next layers, all edges are printed 3x. Another question, the setting so that the nozzle does not go over the finished model so that no wires are pulled over the model. Greetings Auke

First Layer Quality - Official Raise3D Community

Level bed, uneven first layer – Hardware, firmware and software

Strange First Layer after update – Assembly and first prints

Using Cura with EVO, EVO 22, EVO 2X and EVO R

How to disable first layer inspection? : r/BambuLab

Different first layer results every new print – Others (Archive

WeldingWeb - Welding Community for pros and enthusiasts

3D Scanning & Printing

V400 - Problems with the first layer : r/FLSUNDelta

Overhangs first layer – Assembly and first prints troubleshooting

First layer curling at edges causing print to fail – General

Calibrating the print settings for K8400 - Cura (OSX) - Vertex