How to edit gcode? - Is it possible to salvage a job by restarting after a jammed extruder? - Snapmaker 2.0 - Snapmaker: where creation happens

Stepped away for a bit, glad you’re making some progress! Yea, the G92 command is a way to set an arbitrary reference point for future commands. It sounds like you got it, but I’ll just reiterate: that G92 E0->G92 E115.7035 change was because over, say, 1000 lines of gcode 115mm of filament was extruded, and if I don’t change the reference as soon as the first G1 X Y E116 is executed it’ll extrude 116mm of filament. So you have to tell the machine that it’s starting at 115.7 so it extrudes 0.3

All 3D printers 3D printers Creality 3D Ender 3 v3 SE 3D printer +

Dual extruder calibration example - Snapmaker 2.0 - Snapmaker

Unable to configure SM2A350 with Dual Extruder in Cura. What am I

Dual extruder stops to extrude - Snapmaker 2.0 - Snapmaker: where

Extruder Calibration a must - Snapmaker 2.0 - Snapmaker: where

RAISE3D Pro3 Large Format Professional Dual Extruder 3D Printer

What are the rules of thumb with various calibration and 3D print

SnapMaker extruder calibration - Snapmaker Original - Snapmaker

Air Print Recovery - A Success Story - Snapmaker 2.0 - Snapmaker