What causes a regular GCODE X+Y+E command to be considered unknown? - Get Help - OctoPrint Community Forum

What is the problem? Octoprint freezes regularly. I could not find a cause for this in the log files. However, when I check the status of the octoprint server in the command line immediately after the freeze, I see the error message as shown in the attached screenshot. An unrecognized GCODE command is listed here. I assume that this is also the cause of the freeze. Does anyone have any idea what is causing this? PS: I have to add that this freezing occurs when printing but occasionally also w

Trumpton Blog: 2020

Klippers -- A Place for Fellow Users of the Klipper Firmware

Where do these numbers come from that appear to be multiplied to every line of gcode? - Development - OctoPrint Community Forum

81 posts tagged with how-to

Stage 02: Software - Makertech

File sharing with OctoPrint

Marlin 2.x for a CR-10 V3 – The Picky SysAdmin

OctoPi Tutorial for Zim - Software - Zeepro Kickstarter Backers Forums

G-code - RepRap

Some gcode help? - General - OctoPrint Community Forum