ultimaker cura - Anet A8 ignores extruder temperature? - 3D Printing Stack Exchange

I don't understand what's wrong with my G-code. I have set the printing temperature to 195 °C but when I try to print, the target temperature is always 0 °C and printing never starts. I have tried

Is it possible to do sequential printing with Cura? - Quora

Official Creality Sonic Pad 3D Printed Smart Pad Based

Anet ET4 3D Printer Fully Open Source with Resume Printing

ultimaker cura - How to fix wall separation in 3D prints (gaps in

creality ender 3 - Prints on bed are missing parts - 3D Printing

ultimaker cura - Anet A8 not printing over heat bed - 3D Printing

Official 3D Printer Creality Ender 3 Neo Upgraded CR

Ecam Eurobot

g code - What is a printer console/terminal? - 3D Printing Stack

Cura 4.10.0 Pause at Height/Layer corrupts line width and layer