M600 refuses to work? Dual extruder issue - Snapmaker 2.0

So, I’m trying to pause my print to inlay a laser engraving. I can not for the life of me get M600 to work for some reason. I’m printing solely with Extruder 2(T1) and every which way I enter the M600 command, it just skips right past it. Not sure what I might be doing wrong. These are the methods I’ve tried; M600 T1; T1 M600; T1; M600; T0 M600;(interestingly, this switches to Extruder 1(T0) and then proceeds through the print as if M600 was not there at all. I believe I’ve also tried str

Dual extruder warning - Snapmaker 2.0 - Snapmaker: where creation

Sovol SV07 Plus Review: 3D Printer Testing, Settings and Tips

Instructions, Embedding a mesh into 3D print

Snapmaker2-Controller/Marlin/Configuration.h at main · Snapmaker

PrusaSlicer 2.2.0-alpha2 – PrusaSlicer – Prusa3D Forum

Sovol SV07 Plus Review: 3D Printer Testing, Settings and Tips

How To Succeed When 3D Printing With PVA Support Material

J1 Community FAQs - Snapmaker J1 - Snapmaker: where creation happens

Dual Extruder stuck in bed level calibration - Snapmaker 2.0