Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Hey Guys, So I had to put in new thermistor recently, did some other structural changes (60mm height increase) and wired in a fan which isn’t currently connected. Yet now I am getting this issue with my hotend where once the print start the temperature drops even though it looks like the extruder is still rocking it. I ran PID autotune, stored the values, brought the bed and then the hotend up too 230C using Repetier. Then I dropped in the GCODE. You can see down below the temperature curve. T

Purchase Advice Megathread: What To Buy, Who To Buy It From, And More, In July 2018. : r/3Dprinting

TweakTown's Guide to 3D Printing: Part 1 - What makes up a 3D Printer?

Review: LulzBot Mini 3D Printer - Make

Print solid and flexible filaments on your LulzBot® TAZ 3D printer without changing toolheads! Simple installation- Bolt it on, plug it in, adjust

E3D Titan Aero toolhead for Lulzbot TAZ

I've got like an hour and a bit left of my print. Why did this happen? : r/FixMyPrint

Faster Dissolution Rate: PVA filament begins to dissolve after 1-2 minutes in water at 50°C. Creative Freedom: Sainsmart PVA filament provides stable

SainSmart 1.75mm PVA Dissolvable 3D Printers Filament, Upgrade Water Soluble Support Filament for 3D Printers -0.5kg/1.1lbs (Natural), Dimensional

Extruder Struggling - AO-101 & AO-100 - LulzBot

3D Printer Review: LulzBot AO-101 - 3D Printing Industry

TweakTown's Guide to 3D Printing: Part 1 - What makes up a 3D Printer?

Flash printer - AO-101 & AO-100 - LulzBot

Extruder Struggling - AO-101 & AO-100 - LulzBot

3D Printer Review: LulzBot AO-101 - 3D Printing Industry

Can't wait explore the world of 3D printing with my Christmas gift! Is there anything I should know that not a lot of people talk about? : r/3Dprinting