Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from

Scalable extra prime

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Scalable extra prime - UltiMaker Cura - UltiMaker Community of 3D

I'm using Ultimaker Cura to splice a print for an Ender 3. How do

Travel settings

Travel settings

too much retraction at beginning - Improve your 3D prints

Cura Alpha 🎄 Tree Support Spotlight 🎄 · Ultimaker Cura

Negative retraction extra prime amount · Issue #2667 · Ultimaker

10 Good Reasons to Use Cura

CURA ultimaker Community

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

how to make this print faster? : r/ender3

Cura for Bambu X1 and P1 Series by AmaZz0r